Prep Tips for the Commercial Painters to Apply During a Project

Paint works are a little complicated than we think. Its not just about splashing colours on the surface. A good paint work is often about how well the surface has been prepared. If you are thinking of hiring professional painters in Subiaco, to get your commercial space painted, first note its essential that they must go all out to prep up the surface. In the following lines we have tried to sum up what all steps professional commercial painters would adopt for that perfect finish. Have a look: 

Gathering the right kind of supplies 

Basically, half of the job depends upon the kind of supplies used. Before preparing the surfaces for a painting job, its essential to get the right kind of supplies. Just to make sure there are adequate supplies, check on what you will need and these might include protective clothing, safety goggles, step ladder, hand brush, filler knife, flat scraper and a bucket. Don’t forget the dust mask and the knee pads and gloves. 

Clean up the walls first 

Walls are usually cleaned using the hand brush as the tool effectively loosens surface dirt and paint from the walls. This is followed by using a scraper to again loosen and remove old paint and chipped masonry. 

After the wall is scraped fully its important to make use of a hand brush in order to smoothen the surface and remove any kind of remaining paint and masonry. 

When the wall gets extremely dirty, its best to scrub them using diluted detergent and then rinsing it off using clean water. 

Repair the cracks 

Now the next step is about fixing the damage. When the wall shows cracks or some amount of loose render, external fillers must be used. Usually, commercial painters in Subiaco would generally use a ready-mix depending on the needs. In order to fix the damaged area, they will firstly dampen the area and the crack by spraying water on it. They will use the corner of the dry filler knife in order to create the inverted “V” as this process is useful in helping the filler remain in place. When the damaged areas showcase wider and deeper cracks, fillers are generally used in layers and let to dry. 

Addressing problems 

Before painting the walls, professionals will address the common problems like removing mould and algae by means of brushing or scraping. When the weather is drier, the painters will apply a fungicidal wash and leave the surface for drying. In case if the walls are chalky and porous the best way to solve it is by priming it up with an effective stabilising solution. 

These are prep tips that professional painters apply while working on a painting project.